The Type 34 ISS is capable of using the following Star Army Science Scanner, Type 31 modules; which gives it a greater range of function.
The Ke-G1-E3103 is not supported to the risk it poses.
The ISS appears as a small small module with a transparent blue dome. Typically mounted on the ceiling of a passageway or room. Inside the dome the scanner assembly can be seen. The unit can be configured for either two or three sensor modules by replacing the armature.
The Type 34 ISS was designed by Jalen Sune at the request of a former crew member, Kage Yaichiro. The work was relatively simple, just a matter of expanding on his earlier design and was in fact something he originally considered.
Installation of the Type 34 ISS is at the discretion of the ship commander. Typically the units are installed to provide coverage over critical ship sections. However, it is possible to install them to provide ship wide coverage. Each unit must be connected to ship power and tied into the ship's computer network.
The Type 34 ISS is controlled by the ship's on-board computer and scans are run at predetermined intervals.
Default scan rates are as follows:
|Normal||once every 30 minutes|
|Alert||1 per minute|
|Combat||60 scans a minute|
The Type 34 ISS requires routine calibration to maintain efficiency. Calibration should be done once every 3 months.